SP FLASHTOOL

Whst is SP flash tool? it is an application that mainly helps you to flash Stock ROM, Custom recovery, and fixing in some extreme cases ( firmware update, Flash recovery, unbrick bricked Android device, etc.). SmartPhone FlashTool is working with MediaTek Android smartphones (MTK based) You can Download SPFlashTool from our downloading section. You need to load the scatter file for MTK based device for functioning.

ALSO READ : How to flash android phone from pc using sp flashtool

• Flashing to Android stock-ROM (scatter-based)
• Flash Custom ROM (scatter-based)
• Application for Fixing Bricked device.
• Advanced Memory testing and verifying.
• Read / Write parameters.
• Erasing / Formatting / Reset Your MTK-based device.

---

• Pc or Laptop
• USB data cable for the device
• Drivers (MediaTek USB-VCOM drivers ). You can see the above tutorial and download links
• Scatter file + files to be flashed
• Backup the device (forum.hovatek.com/thread-468.html)
• SPFlashTool Download from the above links.

How to flash the firmware using SP Flash tool

You will need some requirements which are listed below,dont worry i am providing you download links to easily access what you dont have.

Requirements

1. 1. The latest version of the SP flash tool. Click here To Download.
   2. Working USB cable.
   3. MediaTek android phone.
   4. MediaTek USB driver. Click here To Download.
   5. Scatter file (for flashing android).
   6. Working internet connection.

Step 1: 

Install the drivers and update them.

Step 2: 

Unzip the downloaded SP Flash tool and launch flash_tool.exe. 

For the tool to launch succesfully make sure to turn off any anti virus or anti malware .By doing this you will be good to go.This is how a succesful launched sp flashtool should look like.

You are already close to flashing your device ,only few steps ahead remaining, follow up

You have your flashing tool  ready, load your firmware to the tool.

Now in the firmware folder you downloaded, open it and you will see files inside and a notepad document called a scatter file. Now, go back to your flashing tool and load that scatter file. To load the scatter file, click on “scatter loading.” This will take you to where the notepad document is located. If it doesn’t, find it in the “firmware” folder you extracted. Now don’t be surprised if you don’t see the other files you saw before in that folder. It is because it is only the scatter file that is identified

Step 5: Choose Download Only and begin the download.

Step 5:

 After downloading it connect your phone through the USB to the computer/laptop. ( your phone should be switched off)

Step 6: 

The phone will start flashing immediately after connecting it to your computer/laptop.

Step 7: 

Wait for a while the downloading will be done and a green tick will appear on the screen.

Step 8: 

Disconnect your phone from the computer and the power it up. Your phone will now boot with its logo and will take a little longer to fully power up because it takes time to integrate the new firmware into the phone to sync with the hardware.

If the process stops automatically then choose the Format All + Download option and follow the above steps carefully.

CAUTION!

Please note that every Phone Model uses its ow firmware model, Do not write a wrong firmware to the wrong firmware. This is a very delicate procedure and can break your device anytime f not handled with care .

I suggest you check my full video Tutorial for you to be able to go through the process easily.